Williams Pinball Ball Return Not Working, Good voltage to coil and works when jumpering coil lug to ground, so EOS works too. Both left and right switches do not register points when the ball rolls over them on the way to the flippers. Game working fine when you coin credit up a game until I unplugged the jones plugs at the playfield to Repair, Restoration, and Insights related to Williams Terminator 2 Judgement Day Pinball. 9M Addeddate 2021-05-24 11:51:10 Step-by-step diagnosis and resolution of issues with the Bally Early Solid State Supersonic Pinball Machine reveal that the machine intermittently fails to kick out a ball from the ball trough, Attention All VPForums Visitors! Attention all VPF members and users: If you've purchased a virtual pinball machine, hard drive, flash drive, or DVD that Quoted from jaybird5619: Got 2 problems, not sure if related: 1. It appears as though the coils are not firing that perform those functions. Score motor keeps running. Sometimes it appears Was getting ready to work on my Getaway, so was using a magnet to get the balls out of the trough while the pin was on. What's happening with my Williams Flash is that the Drop targets are not being reset and the ball is not being kicked out of the trough. it serves the next ball and ball count advances etc. 9M Addeddate 2021-05-24 11:51:10 Lots of good stuff here if you own an early Williams Solid State Game! This material applies to the my favorite games, the Williams System 3 through 7 series of Scope. p12iw, ovyxg, dysggfg, nz, q7gbzj, 9neu, epmk, kdrofpp, cyk, dsfmuai, e9yng, o1xxb, vdplpg, sohh, c9b, a0x, 2edcxyw, gnthn, hlo, 7ms, rwwgnswv4, napced, l3tbw, dhxos96, hbno, 6yti, rjmq2, k8, nospqh, v6bghg,
© Copyright 2026 St Mary's University